"I am already in the industry working with MacMahons and I believe that my training has greatly increased my prospects for future advancement in the industry.
During training sessions everyone was given equal time with both the practical and theoretical segments of the courses and everyone was made to feel they were an important member of the group."
Mick Connolly
Immersive Operator Training Graduate
Grader Operations
Unit Code
- MNMOMS306A - Conduct Grader Operations
 |
 |
Subject & learning outcomes
This module will provide you with the basic skills, knowledge and information to safely operate a Grader.
Participants will be able to:
- Operate a Grader safely to the Metalliferous Mining unit MNMOMS306A Conduct Grader Operations.
- Set Correct Position and blade height
- Spread heaps and level material
- Maintain level floor and spillage clean up
- Build safety windrow
- Grader position on ramps
- Use wheel lean appropriately
- Use scarifies effectively
- Cut and fill as required
- Use basic cuts to form roads
Module details
- OH&S Requirements
- Walk around Inspections
- Boarding Procedures
- Pre-Start Operation Checks
- Cab Systems Checks
- After-Start Checks
- Operating Techniques
- Park up and Shut Down
- Written Test
Assessment methods are of written theory and practical observation. Therefore if you have any literacy problems please advise Immersive Operator Training staff at point of Application.
Favourable assessment outcomes from this training result in a Statement of Attainment in Partial Completion of a Certificate II in Metalliferous Mining (Open Cut).
Scope of registration
The Scope of Registration Encompasses Nationally Recognised Training in the following:
- MNM20106 Metalliferous Mining (Open Cut) AQF II
- MNM20306 Metalliferous Mining (Processing) AQF II
- BCC30603 Single Units of Competence
- MNM30106 Single Units of Competence
- MNC20104 Single Unit of Competence
Contact ImmersiveOT today for booking enquiries (Tel: 1300 883 230)